Controller REG - 06

characteristics

The controller REG - 06 is adapted to control the operation of the boiler equipped with a pump hot water and a fan which fuels combustion of fuel in the boiler.The controller is also equipped with the entrance of the room thermostat, which allows you to change the parameter of the boiler after reaching the desired temperature in the room.

The main task of the controller is to control the fan, which feeds fuel combustion in the boiler. On reaching the required heating water temperature controller switches to maintain the temperature. The controller also supports the hot water tank. DHW pump starts working when the controller detects too low temperature od the tank. You can also specify the mode of operation of the pump DHW - priority or not.

The controller also allows for the control with the room thermostat.This allows you to control the heating in relation to the prevailing temperature in the room. The controller is also equipped with a system of self-control (temperature sensor fault detection) as well as monitoring mechanisms to prevent the passage of boiler operation beyond the period of safety for central heating.

technical information
Specification
Sensors KTY-210
Measurement range 0 - 120°C
Resolution measurements 0,1°C
Time of measurement 1 s
Reading data LCD Display 2 x 20
Control outputs
Fan ~230V 2A (0,8A)
The pump of central heating ~230V 2A (0,8A)
Pump of hot water ~230V 2A (0,8A)
Alarm STB ~230V 2A (0,8A)
Security
Thermal STB (95°C)
Electric Fuse 2A
Inputs
The room thermostat The break contact
Temperature sensors KTY-210
Signaling
LEDs Signalling output states
LCD Display Messages, measurements, settings
Power ~230 V 50 Hz 8VA
Working temperature 5°C - 50°C
Casing protection degree IP20
The dimensions (length x width x height)
The controller module 175 x 65 x 30 mm
Executive module 135 x 90 x 65 mm
Sensors KTY-210

 

 

unfold fold